native instruments controller editor templates missing

With the MASCHINE and TRAKTOR software synced, and your MASCHINE controller talking to both of them, you can begin making a MASCHINE mapping for TRAKTOR.Ī typical mapping might have an effects section, browsing controls for browsing playlists and loading tracks, Hotcues, Loop controls, Play, Sync, Tempo Bend, Flux Mode, BeatJump, and then perhaps a few of the programmer’s own secret weapons. The same key combination will switch you back into Application Mode.

Shift + Control (MASCHINE MK2 & MASCHINE MK1).

Shift + Channel (MASCHINE MK3 & MASCHINE STUDIO).

To start, make sure your MASCHINE is in MIDI Mode. This gives you a whole new layer of assignable buttons, knobs and faders that you can program to control virtually anything inside TRAKTOR – called a mapping. However, MASCHINE – as with most Native Instruments controllers – has what’s called a MIDI Mode. In normal use, when controlling MASCHINE, the controller is in what’s known as Application Mode. However, Ableton Link is still a work in progress, and the timing tends to drift in tempo sync mode, so we recommend the old-school method of sending a virtual MIDI clock from TRAKTOR to MASCHINE. With Ableton Link, you can synchronize MASCHINE to TRAKTOR with one push of a button in each program. Obviously, if you want to actually do this during a set, then you’ll want to synchronise playback timing of the two applications. One of the beauties of the MASCHINE hardware is that it can be used to control both the MASCHINE and TRAKTOR software simultaneously. This tutorial refers to the MASCHINE MK3 hardware throughout, as that’s the device we are using, but the same techniques are applicable to all MASCHINE models. In this in-depth tutorial, you’ll learn how to do all of this and more, creating a custom TRAKTOR mapping for MASCHINE from scratch. And how about mapping MASCHINE’s multicolored pads to show which TRAKTOR features are active at a glance? Use Modifiers and Pages to create layers of controls, massively multiplying what your MASCHINE setup is capable of. You can map multiple features to one control to turbocharge your on-stage workflow and creativity.

Almost any feature in TRAKTOR can be mapped, meaning that it can be controlled with MASCHINE’s pads and buttons. With the MK3 model featuring 16 RGB-backlit pads, 8 knobs with visual readout, a tactile encoder, buttons aplenty, and multiple pages of controls, there’s enough mappability here to handle all the Hotcues you can throw it at – and then some.īut back to that mapping functionality. To do so, you must first uninstall the current version of Controller Editor and then reinstall version 1.7.4 as explained below.Ever wanted to go beyond the tried-and-true “decks and mixers” control paradigm? Through the magic of mapping, anything with a MIDI output can become your new TRAKTOR controller, and there are few better blank canvases for this than MASCHINE.

If you wish to edit the MIDI properties of your controller you can downgrade to Controller Editor 1.7.4. Since Controller Editor 1.8.0, support for the following NI devices has been discontinued: Some legacy products are no longer supported and thus their templates cannot be edited. Legacy products no longer supported with current version of Controller Editor Here you can define what kind of MIDI messages are assigned to the controls of the keyboard in MIDI mode. You can access the MIDI Assignment editor by clicking the MIDI icon in the top right of the KOMPLETE KONTROL software when your S-Series MK2 keyboard is connected: If your controller does not appear in Controller Editor, it is due to the reasons listed below: Hardware Controllers which are configured from their Application Different hardware controllers will allow for different abilities in configuration of their outgoing MIDI Control Changes.

Native instruments controller editor templates missing